UV Water Sterilisers

Ultraviolet light that kills bacteria, viruses and cysts without adding anything to your water.

$0 CALLOUT FEE IN BUSINESS HOURS | FREE QUOTES | SAME DAY SERVICE

Google

Overall Rating

4.9

Five stars

(2,800+)

Brightest & Best Business Awards: Winner 2019, Winner 2024, Winner 2025, People's Choice 2025, Finalist 2023

NOW SERVICING NORTH SYDNEY

  • 35+ Years of Combined Experience
  • Yes, a Real Plumber Reads These Messages Too
  • The Kettle Is Always On at Head Office
  • $0 Call Out Fees
  • Every Job Photographed, Every Price Upfront
  • We Answer the Phone. Revolutionary, We Know.
  • Trusted by 15,000+ Sydney Families
  • No Call Centres. You Get a Human in Sydney
  • Your Neighbours Probably Have Our Fridge Magnet
  • Onsite in 30 Minutes Guaranteed
  • Boots Off at the Door. Every Single Time.
  • 2,800+ Google Reviews and Counting
  • In the community For the community

THE SHORT ANSWER

In short

A UV steriliser shines ultraviolet light through the water as it flows past, which stops bacteria, viruses and cysts such as Giardia and Cryptosporidium from multiplying. Nothing is added, so the taste does not change. It removes no chemicals, needs clear water from a filter first, and needs power. It is for tank, bore and rainwater: Sydney mains water is already disinfected. A whole house filter with UV costs about $2,800 to $3,800 installed.

HOW IT WORKS

Filter first, then light

A UV lamp sits inside a quartz sleeve, a clear glass tube, in a steel chamber. As water flows past, the ultraviolet light damages the DNA of bacteria, viruses and cysts so they cannot reproduce.

It only works on clear water: sediment can shade germs from the light. That is why UV always comes after sediment and carbon filters, as in Puretec’s Hybrid systems.

The dose matters, measured in millijoules per square centimetre (mJ/cm²). Puretec rates its Hybrid R10 at 70 litres a minute at 30 mJ/cm², which it calls the industry standard for drinking water. Certified UV claims are made to NSF/ANSI 55.

A Proximity plumber talking with a customer in her kitchen

WHAT IT DOES AND DOESN’T

What it removes, honestly

Removes or reducesResultNotes
Bacteria such as E. coliYesPuretec says the Hybrid R10 kills up to 99.99%
VirusesYesWhen the water is clear and the lamp is working
Giardia and Cryptosporidium cystsYesListed by Puretec for the Hybrid R10, at the right dose
Chemicals, PFAS, metalsNoUV changes nothing chemical; the filter stages do that
SedimentNoSediment must be filtered out first, or it shields germs
TasteNo changeNothing is added to the water
During a power cutNo treatmentThe lamp needs power to work

Facts checked 9 November 2026. Sources: Sydney Water, NSW Health, Standards Australia and Puretec.

WHO IT SUITS

Is it right for you?

Rainwater tanks

Tank water used in the house, for drinking, showers or the kitchen.

Bore water

Private water that has had no treatment at all.

Sydney mains

Usually not needed: Sydney Water already disinfects its water.

DOSE AND FLOW

Why the flow rate decides the dose

A UV steriliser works by dose: how much ultraviolet energy each litre receives as it passes the lamp. The faster the water flows, the less each litre receives. That is why a UV unit is sized to the highest flow your pump or water service can deliver, not to the average.

Puretec publishes three flow ratings for the Hybrid R10 (Puretec Hybrid R10):

DoseHybrid R10 maximum flowWhat that dose is used for
16 mJ/cm²130 L/minWater that is already safe; NSF/ANSI 55 Class B units at this level make no health claims
30 mJ/cm²70 L/minWhat Puretec calls the industry standard for drinking water
40 mJ/cm²54 L/minThe dose NSF/ANSI 55 Class A units are built to, for water that may carry germs

If your pump can push more than the rated flow, a flow restrictor or a larger unit keeps the dose up. We check the pump’s maximum output before we choose the size.

WATER QUALITY FIRST

When water is too dirty for UV

UV light has to reach every germ. Cloudy water, iron, manganese and hard water shade the light or coat the quartz sleeve. Puretec’s Hybrid guide sets these upper limits for water entering its UV systems:

MeasurePuretec’s upper limit
HardnessLess than 110 mg/L
IronLess than 0.3 mg/L
ManganeseLess than 0.05 mg/L
Hydrogen sulfideLess than 0.05 mg/L
Suspended solidsLess than 10 mg/L
pH5 to 9

Tank water off a clean roof usually sits inside these. Bore water varies a great deal, so it is worth testing first; it may need iron removal or extra filtration before the UV. If you are unsure, Puretec offers a UV transmittance (UVT) test to check whether more filtration is needed (Puretec Hybrid guide).

INSTALLATION

What a UV install needs

  • A 240 volt power point close by. Puretec advises against long extension leads and recommends an RCD (safety switch) on the circuit
  • Surge protection: Puretec supplies a surge protector, which must be kept dry, and says the warranty may be voided without one
  • Metal pipe or fittings for at least 1 metre after the UV outlet, as Puretec specifies, rather than plastic
  • Filters before the UV chamber, so clear water reaches the lamp
  • Pressure of 300 to 875 kPa for the Hybrid E series, with a pressure limiting valve above 500 kPa
  • Room to slide the lamp and quartz sleeve out for servicing

On a new system where the pipes have never been disinfected, Puretec recommends flushing the pipework with a sanitiser and leaving it for at least an hour, preferably overnight, so bacteria already living in the pipes are not left behind.

LIVING WITH UV

Day to day with a UV system

  • After the lamp has been off, Puretec says to allow 2 minutes for it to reach full strength before running water.
  • The first water after the system has been idle can feel slightly warm, because the lamp gives off heat. Run the tap briefly.
  • A blue light means it is working. An alarm and a flashing red light mean the lamp is due or has a fault.
  • Do not silence the alarm and forget it: Puretec’s controller counts down 365 days to the lamp change, and a silenced alarm comes back after 7 days.

MYTH OR FACT

UV steriliser myths

MythFact
UV purifies water completelyUV deals with germs only. It removes no chemicals, metals, PFAS or sediment; the filter stages do that.
If the lamp glows, it is workingLamp output fades with age. Puretec rates its lamps for 365 days, and the timer and alarm tell you when to change it.
UV changes the waterNothing is added and nothing is taken out chemically. The taste stays the same.
Sydney mains water needs UVNot usually. Sydney Water disinfects its water before it reaches your tap.

WHAT IT COSTS

Prices in Sydney

Typical Sydney prices, supplied and installed by a licensed plumber, including GST. You get a fixed price before any work starts.

SystemInstalled priceNotes
Whole house filter with UV$2,800 to $3,800A Puretec Hybrid system. Needs a power point nearby.
Rainwater tank filter with UV$2,200 to $3,800A Puretec Hybrid rainwater system, sized to your pump.

WHAT WE INSTALL

The Puretec system we fit

We install Puretec Hybrid systems, which combine sediment and carbon filters with a UV chamber in one unit, with a lamp countdown timer and an alarm when the lamp is due. On 9 November 2026 Puretec listed the Hybrid R10 at $3,028.81 including GST, for the equipment alone.

Warranty: Puretec lists 3 years for its Hybrid systems (1 year parts and labour, then 2 years parts), and 1 year, pro rata, on UV lamps (Puretec warranty). We confirm the exact term for your model with the quote.

Change the UV lamp every year: Puretec rates it for 365 days, and its controller counts down to the change. Check the quartz sleeve about every 3 months, as Puretec advises, and clean it if a film has built up. Change the filter cartridges every 6 to 12 months. We quote the lamp change with your yearly service.

QUESTIONS

Questions about uv sterilisers

MORE TYPES

Other water filters

READ MORE

Water filter guides

CLEAN WATER FOR YOUR FAMILY

Talk to us about your water

A licensed plumber will tell you honestly what your home needs, and give you a fixed price before any work starts. $0 call-out Monday to Friday, 7:00am to 3:00pm, and Saturday, 7:00am to 12:00pm. Outside those times, and all day on NSW public holidays, the call-out fee is $385 ($350 plus GST), paid before we send a plumber.

Licensed NSW 285594C

Every enquiry answered in 15 minutes

Lifetime labour warranty

4.9 from 3,000+ reviews